And in my network I have all DHCP assignments starting at 192.168.1.100, reserving everything below. When I setup my eero, I found the 'advanced' setting to configure the DHCP range to start with 192.168.1.0, which is what my static-IP-configured NAS was expecting and consistent with how I am used to accessing my home network. While people are always saying AFP (Apple's own legacy networking protocol) is "on its way out", I've found it still the most reliable way of connecting to a NAS with a Mac computer. In my case it had to do with the SMB implementation Apple uses, it's non-standard/proprietary, so rather than using the standard libraries everyone else does, they rolled their own. I f you can Hear Two Beeps, Please follow my other documents.For what it's worth, although I don't have a QNAP, I do have a Synology NAS and had similar issues with accessing it from my Mac computers (Windows PC's were OK). To fix this problem, please follow “Qnap firmware Recovery / Reflash” Documents. If you cannot Hear the two beeps, the NAS Firmware is Damaged. If you cannot hear first beep, Please contact your local reseller or distributor for repair or replacement service. You will hear a beep after pressing the power button, followed by 2 beeps 2 minutes later. I take this document from Qnap helpdesk, It continues with “send it to technical departmant”, but you can solve it by yourself, so please keep on reading my fixed document If you still cannot access the NAS after Step 3, please do the following: This will clear the administrator password and network settings (DHCP will be used and the default user name and password is: admin/admin).After two beeps on the system startup, run the Finder again to find your NAS or open a web browser and enter (If your NAS is connected to your PC directly, the NAS IP is 169.254.100.100:8080). ![]() Reset the NAS by pressing the reset button for 3–4 seconds.If the Status/Power LED flashes red or red and green alternatively, the NAS is not initialized or the hard drive(s) are not ready. Check if the Status LED (same as the Power LED for some models) glows green.Check your LAN cable connection and the LAN LED is flashing.If you still cannot access your NAS by the Finder or by entering the NAS IP in the web browser directly, please do the following: If the problem persists, check if other anti-virus programs or firewalls are running disable them and run the Finder again. Windows 7 users can click “Allow access” to unblock the Finder from Windows Firewall. If you are using Windows XP SP2, click “Unblock” when the Windows Firewall dialog appears to run the Finder. Uncheck the option “Internet Connection Firewall”. ![]() Click “Properties” and select “Advanced” tab.Click “Network Connections” and double click the icon for your network connection. ![]() Go to “Control Panel” > “Network and Internet Connections” in the Category view or go to “Network Settings” > “Control Panel” in the Classic view.If you are using Windows XP SP1, please do the following: Make sure your NAS and the PC are connected to the network correctly. What is RAID? Redundant Array of Independent Disks.Warning : Re-Launch Process & The File System Is Not Clean.Qnap Becomes Unreachable When I Plug Qnap to My Network.Web-based Distributed Authoring and Versioning (WebDAV).What is Stress Test and How to Do Guide.Qnap Benchmark, Lun Speed & Stability Test.
0 Comments
Leave a Reply. |